For the past week my 2012 cruze lt 60k miles has been flashing stabilitrak check service traction control and the radio cuts out.
Check engine light flashing service stabilitrak chevy cruze.
There will always be trouble codes associated with the check engine light blinking.
It is really only gets use in an emergency situation.
If the light is flashing take your vehicle in immediately to be diagnosed and inspected a flashing light indicates a serious problem with one of your vehicle s components.
I have read a bit about it and there may be a problem with a negative battery cable or possibly a troublesome psv and or faulty sensors.
Took it to the dealership and they found a bad water pump cracked housing for thermostat blown head gasket and bad purge solenoid valve.
When driving there was a noticeable reduction in acceleration power.
All within 4 months.
Blinking check engine light diagnosis.
But follow the obdii codes.
Seems like the cruze has a lot of problems with the check engine light and service stabilitrack flashing.
If the light is not flashing check the gas cap.
When starting the car a previously used 2015 chevy cruze lt the check engine light came on and the messages service traction control and service stabilitrak appeared.
These trouble codes will be able to tell you where to start hunting down the problem.
Loss of stabilitrak is not really going to be noticed during normal driving.
Service stabilitrak warning the number one indication that something is wrong is your cruze s service stabilitrak warning light itself.
Here are the most common issues that end up causing the check engine light to flash.
Oftentimes if the gas cap wasn t tightened enough the check engine light will display.